This is a 22 ounce stainless steel lined, red cedar cladded exterior, beverage container. The lid screws on and has a straw in the middle. The straw and lid are safe to send through the dish washer. The main body is not dishwasher safe— it’s recommended you rinse out the inside in the sink and quickly hand dry the outside. Although this is finished with a multi-layer process, wood and water love each other and will do funny things when left to their own devices.
This tumbler is made from laminated hobby board that was used on a different project. (I had a lot of pieces from this project that I just couldn’t throw away). The pieces are all glued together at the factory to make a custom board size from 1×1 pieces of pine. I took the pieces and glued them to make the blank for this mug. I did give a bit of a terraced area near the top to look kind of what I see at the store as “popular” plastic models. The screw on top does stay on when knocked over (ask me how I know).
This will still be one of those mugs that will be completely different to everyone else’s same colored Stanley or yeti mugs.
As wood is thermally resistant, and the foaming polyurethane glue I use to keep everything in place is also an insulator, this beverage container will do a reasonable job in keeping hot things hot and cold things cold (without all the summertime sweating).
This mug is almost 10 inches tall and close to 5 inches wide. I try to make my beverage containers available to fit most car cup holders. This is just a touch over 3 inches at the base.
Ships via USPS Priority Mail Flat Rate.
This is a 22 ounce stainless steel lined, red cedar cladded exterior, beverage container. The lid screws on and has a straw in the middle. The straw and lid are safe to send through the dish washer. The main body is not dishwasher safe— it’s recommended you rinse out the inside in the sink and quickly hand dry the outside. Although this is finished with a multi-layer process, wood and water love each other and will do funny things when left to their own devices.
This tumbler is made from laminated hobby board that was used on a different project. (I had a lot of pieces from this project that I just couldn’t throw away). The pieces are all glued together at the factory to make a custom board size from 1×1 pieces of pine. I took the pieces and glued them to make the blank for this mug. I did give a bit of a terraced area near the top to look kind of what I see at the store as “popular” plastic models. The screw on top does stay on when knocked over (ask me how I know).
This will still be one of those mugs that will be completely different to everyone else’s same colored Stanley or yeti mugs.
As wood is thermally resistant, and the foaming polyurethane glue I use to keep everything in place is also an insulator, this beverage container will do a reasonable job in keeping hot things hot and cold things cold (without all the summertime sweating).
This mug is almost 10 inches tall and close to 5 inches wide. I try to make my beverage containers available to fit most car cup holders. This is just a touch over 3 inches at the base.
Ships via USPS Priority Mail Flat Rate.
Image 1 of 5
Image 2 of 5
Image 3 of 5
Image 4 of 5
Image 5 of 5
